Problems and solutions of toilet paper rewinder

　　The weight of each roll of paper stick is different. The number of windings is fixed on the computer. But the weight is always increasing.

　　Treatment method: first of all, there are three reasons why the weight of the rewinder paper is different. First, your width is different every time you rotate. Second, the quantitative banner of the original paper has changed. Third, you don't stretch the roll and form part of the wrinkles, so your weight becomes larger.

　　2 . Start now, always waste a lot of paper. How to use it reasonably? Treatment: how to use paper to reduce waste. This is what you usually pay more attention to; First of all, you have to work hard on buying. The width of the large paper roll you buy should be appropriate, so cut less on the two sides. Secondly, when rewinding, try not to break the paper and avoid unqualified products, which can reduce waste.

　　3: The paper roll is always crooked when the paper cutter wants to remove it. How to adjust the horizontal point. Processing method: the paper roll cut by the paper cutter is always crooked. This is to make your large paper roll parallel to the drum of the rewinder, otherwise the paper will be crooked. In addition, the radian of your stretching roller should be adjusted well, otherwise there will be deviation.

　　The right side of the rewinder roll is always centered on the broken part, resulting in no roll. Cannot scroll. Treatment method: if the right side is always broken, then check whether the paper tension on this side is greater than that on the left. It is not that the stretching roller or large roll of paper is more inclined, resulting in too tight and broken paper on this side.

　　Treatment method: toilet paper has good ink absorption. In rainy days, due to the high air humidity ratio, it may have a large number of outer and inner layers. The drying is different, resulting in the deformation and strength change of the paper, forming a roll of paper, which is easy to be damaged in time and quantitative bias. To eliminate this problem, it is necessary to consider the ventilation of the workshop and insist on boring the workshop as much as possible.